Projects

From chip to board to product: VHDL digital design, PCB prototyping, edge-computing cameras, deep learning for signal classification, parametric 3D printing.

AI Camera: Raspberry Pi Image-to-Video System

Code

AI Camera: A Raspberry Pi Image-to-Video Generation System

A Raspberry Pi in a red 3D-printed shell: take a photo, or describe a dream, and it turns that into a short film with real camera language.

Course Project · Innovative Experiments in Electronic Science III · SUSTech · Sep. 2025 – Jun. 2026

  • Raspberry Pi
  • Picamera2
  • PySide6 / Qt
  • OpenAI API
  • Runway API

Speaker Identification System

Code

Speaker Identification with MFCC + GMM

Speak for four seconds and the system decides who you are — or decides you are not on the list. Built from scratch in MATLAB; 93.1% end to end.

Course Project · Team of four (my share: 25%) · SUSTech · Sep. 2025 – Jan. 2026

  • MATLAB
  • MFCC
  • GMM / EM
  • CMVN
  • Voice Activity Detection

SDR Text Transceiver

SDR Text Transceiver: M-PSK over USRP

Encode a passage of text, packetise it, modulate it, push it out of a USRP antenna — then pull it back out of the air and reconstruct the original.

Course Project · Team of two · SUSTech · Feb. 2026 – Jun. 2026

  • LabVIEW
  • USRP
  • Software-Defined Radio
  • M-PSK Modulation
  • Frame Synchronisation

Modulation Classification with Deep Learning

Train a neural network to listen to a radio signal and tell you which modulation scheme it uses.

Course Project · SUSTech · Sep. 2025 – Jan. 2026

  • MATLAB
  • Digital Communications
  • FFT Spectral Analysis
  • Convolutional Neural Networks

Digital Design Using VHDL and PLDs

Build digital circuits from scratch in a hardware description language, then write the tests that prove they are actually correct.

Visiting Student (Course-based Design Project) · Stony Brook University · Jan. 2025 – May 2025

  • VHDL
  • FPGA
  • Active-HDL
  • Self-Checking Testbenches
  • Sequential Logic Design

Fine-Pitch Chip Removal and Adapter PCB Design

Lift the main chip off a retro handheld console, solder it onto a PCB we drew ourselves, wire it back through a ribbon cable — and the job is only done if the console still runs.

Course Project · Team of four · SUSTech · Sep. 2024 – Jan. 2025

  • LCEDA
  • PCB Design & Fabrication
  • Hot Air & Hand Soldering
  • NI ELVIS
  • Circuit Debugging

Additive Manufacturing: Car Body Design

Additive Manufacturing: Car Body Design on a Fixed Chassis

The chassis dimensions were fixed; the bodywork was entirely open. Model it, draw it, print it — then measure the real thing and find out whether it actually fits.

Course Project · SUSTech · Sep. 2023 – Jan. 2024

  • Fusion 360
  • 3D Modelling
  • Engineering Drawing
  • Rendering
  • Slicing